1
/
of
1
Kartek
Kartek Wobble Stopper Kit
Kartek Wobble Stopper Kit
Regular price
$250.00 AUD
Regular price
Sale price
$250.00 AUD
Unit price
/
per
Tax included.
Shipping calculated at checkout.
Couldn't load pickup availability
100% American made, overbuilt but not overpriced like the competition. Our wobble stoppers are designed for 3 and 4 link truck trailing arm rear suspension to combine the articulation of a standard 1" bore uniball with the rigidness of a composite bushing. The two slotted end caps guide the range of movement of the uniball to eliminate the rear end sway that is common with link suspension setups on trucks.
The weldable surface is 2" wide. You'll use a 3/4" bolt for the pivot. The 10034WSS are the normal spacers that we provide in this wobble stopper kit and are 3-1/16" wide from mounting tab to mounting tab.
IMPORTANT: A 1" bore uniball is required for this kit and is SOLD SEPARATELY! The kit DOES NOT include the uniball because there are several to choose from. They are listed below.
Kit Includes:
Typical Bolt Length If Using Grade 9 Hex Bolts:
Typical Bolt Length If Using Our 12 Point Flange Bolts:
NOTE: Make sure you make long enough tabs. Our PT1434CM are too short. The wobble stopper is 2-3/4" outside diameter. Divide that in half and you get 1-3/8" from center of bolt hole to outer edge of wobble stopper if it were parallel to the tube that you're welding your tabs to. You'll need even more room to compensate for the fact that the wobble stopper's end plates are oval shaped allowing it to rock slightly left to right.
Kit Includes:
- Two slotted end plates
- Eight 1/2" long 10-32 socket head cap screws (allen bolts)
- Two 3/4" bolt spacers for 3-1/16" tab width
- One 2" wide 2-3/4" diameter weldable housing
- One snap ring (you only need one per wobble stopper)
Typical Bolt Length If Using Grade 9 Hex Bolts:
- 5" long if using standard spacers, stover or nyloc nut, two flat washers and two 1/4" thick tabs
- 5-1/2" long if using extra wide spacers, stover or nyloc nut, two flat washers and two 1/4" thick tabs
Typical Bolt Length If Using Our 12 Point Flange Bolts:
- 4-1/2" long if using standard spacers, stover nut, one flat washer and two 1/4" thick tabs
- 5" long if using extra wide spacers, stover nut, one flat washer and two 1/4" thick tabs
NOTE: Make sure you make long enough tabs. Our PT1434CM are too short. The wobble stopper is 2-3/4" outside diameter. Divide that in half and you get 1-3/8" from center of bolt hole to outer edge of wobble stopper if it were parallel to the tube that you're welding your tabs to. You'll need even more room to compensate for the fact that the wobble stopper's end plates are oval shaped allowing it to rock slightly left to right.
We stock WSSX16T that suits these kits.
Share
